Portable Weighbridge

Frizzell Portable Weighbridge General


General Construction: The bridge is built from two 2.45 metre long by 2.9 metre wide sections. Each section has its own ramps attached and hinged for easy packing. One weigh platform is permanently attached to a hinged wheel set and frame.

The easiest portable bridge to packup, layout and transport.

Laying out the bridge is simple. The rear section is lowered off the transport bogy and unclipped. The front section is pulled beside the back section, disconnected from the towing vehicle and lowered to the ground. Ramps are folded down and the two units connected.

To pack up the drawbar is raised with the attached jack. The bogy wheels are folded down and locked and the ramps folded up. The front unit is backed over the back unit, which is winched up and attached to the bogy frame.

The unit is less than two tonnes and 2.5 meters wide and can be towed with a 4 wheel drive light vehicle. Both layout and packup can be achieved by one person in less than 15 minutes.

Because of its construction the bridge has a very low profile of only 150mm from ground to deck height. The distance between the two platforms can be adjusted for varying truck wheelbases.

Weighbridge General Specification:

Length: Two platforms 2.45 metres X 2.9 metres. Deck Height Above ground: 150mm

Gross vehicle Weight: 30 tonnes maximum.

Certification: Class IV, 100 kg resolution. Load Cells; 8 X 10 tonne.

Indicator: Rinstrum 5230 Truck indicator or equivalent..

General: The output from the indicator can be attached to a weight docket printer or to a computer and supplied software. A large display can also be added.

Portable Weighbridge - Truck

Truck Weighbridge

Truck Weighbridge

Frizzell Fixed Weighbridge

General Discription

The Frizzell Weighbridges are designed to provide cost effective modular units capable of weighing most heavy truck and trailer combinations. The units have a high accuracy and flexibility. From weigh pads to full bridges our modular design allows units to be combined to provide up to 30 tonnes of capacity and 9.8 meters long.

Order/Enquire about this product

* Please note prices exclude delivery

Built strong

The Frizzell weighbridges are built from steel to give long life and rugged construction. Each platform is supported by two steel I beams, with cross braces built as a unit. The platform is separate from the base and is made of reinforced steel chequer plate.


Single axle units are designed around 600mm square pads. For larger bridges, base weighing units are 2470mm long and 900mm wide, two units sit side by side to provide a modular weighbridge 2.9 meters wide with 15 tonnes capacity. Using Span Units the bridge can be extended in multiples of 2.4 meters with increased weight capacity.


  • Individual platform size: 247mm X 900mm
  • Height above floor 200mm
  • Load cells : four per weigh unit. Eight per weighbridge section.
  • Total maximum rated weight 30 tonnes. For a 7.4meter unit.
  • Load Cell performance: non-linearity +-0.02%F.S. Repeatability +-0.02% F.S. Temperature effect on output +-0.02% F.S./10 degrees K. Compensated Temperature Range –10C to 60C Scales calibrated to better than 1% F.S. Safety overload 150% F.S.

Single axle 600mm X 600mm single weigh pads

Two axle Weighbridge

Truck Weighbridge ( 7.4 meters long )

Portable Weighbridge

Please check price list for indicative prices

We can supply weighing systems for silos and bins please enquire for prices.

* Please note prices exclude delivery, setting up costs, and or certification costs. Costs may vary depending on options.

All units have 1 years guarantee with full technical and maintenance backup.

Order/Enquire about this product